Kv2-audio EPAK2500 Uživatelský manuál

EPAK2500User GuideThe future of sound.Made perfectly clear.At KV2 Audio our vision is to constantly develop technologies that eliminate distortion and

Normal set upThe EPAK2500 is designed to actively power one ES1.0 cabinet and associated subwoofer systems. For Normal Mode operation signal is applie

Page | 11Using the subwoofer insertThe subwoofer insert point gives you the ability to ‘insert’ a signal processing device into the ES subwoofer signa

Block diagramPage | 12thpupuw|{thpuhjêpu{oyv|nozpnuhsêv|{jvu{yvswylwyv{lj{pvuwv~lyêz|wwszpnuhsthuhnltlu{jvu{yvs|up{op¢±¥êoê¾ê¤ªêo¡ªªê~tpkê½êoptpk

EPAK2500 SpecificationsPage | 13High Frequency Amplier SpecicationTypeClass AB Push-Pull low inter-modulation Mosfet design with transformer balance

EPAK2500 AccessoriesPage | 14ES Mid/Hi speaker cable MH120, AP6 connectors - 12mpart name: MH120part number: KVV 987 126- 12m (40ft), Mid/Hi Module ho

The future of sound.Made perfectly clear.KV2 Audio, Nádražní 936, 399 01 Milevsko, Czech RepublicTel. +44(0)1423 816868www.kv2audio.com KVV120000-00-0

ContentsIntroductionHow to use this manual 4Icons used include 4Important safety instructions 4Introducing the EPAK2500 5Getting Started

NOTE!CAUTIONC!14. Unplug this unit during lightning storms or when unused for long periods of time.15. Do not connect an EPAK2500 output in

Introducing the EPAK2500The EPAK2500 is a four-way, active control and amplifiation system specifically designed for the KV2 Audio ES Series™ modular

UnpackingUnpack the EPAK2500 and check to see if there is any damage to it. If you find any damage notify your supplier immediately. Only the consigne

Power ON / Bass limitThis is a dual colour LED, when green it indicates that the AC power is on. When red it indicates that the audio bass amplifier l

FeaturesUpper panelPage | 8POWER ON/BASS LIMITSIGNAL PRESENT/MID- HI LIMITTHERMAL(AUTO RESET)0-6dB-3+3+6dB0-6dB-3+3+6dBSYSTEM STATUSBASSSYSTEMMAIN INP

AC Mains switchThe EPAK2500 has a combination AC Mains switch/circuit breaker on the bottom panel. If the switch shuts off during normal use, push it